User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail]
傳真: (八五二) 二六八七 四一二五
26 030206A-1
many phones can be connected to the same line. The REN total of all
devices(printed on the bottom label of each unit)should not exceed five(5).
Disconnect the appropriate units to lower the REN total.
No power on
the handset
unit
• Check the Ni-Cd battery pack for proper connection inside the battery
compartment on the handset.
• The handset rechargeable Ni-Cd pack may need charging.
Does not
charge
• Check the Ni-Cd battery pack for proper connection inside the battery
compartment on the handset.
• Made sure the charging contacts on both the base unit and the handset are in
contact during charging.
• The charging contacts and terminals may need cleaning with an
alcohol-dampened swab.
Range is
limited
• Move the base unit so that it is centrally located in your residence or office and
make sure that the base unit is not located near appliances.
• The handset Ni-Cd battery may be weak. Recharge the Ni-Cd battery.
• Refer to the section “ Improving Cordless Reception”.
Calls
received
flutters or
fades
• The handset rechargeable Ni-Cd battery pack may need charging.
• Choose an alternate channel using the MENU/SCAN button on the handset.
Interference
on reception
• Refer to the section “Improving Cordless Reception”.
Excessive
static
• Refer to the section “Improving Cordless Reception”.
B. CALLER ID SYSTEM TROUBLESHOOTING TABLE
SYMPTOM SOLUTION
The Caller ID
panel is blank
• Check the power connection.
• Check the telephone line cord connections.
• Check the batteries for proper installation.
The Caller ID does
not show the caller’s
name and/or phone
number
• The Caller ID unit will not function until you have Caller ID service
provided by your local phone company. Call your local phone company
to have Caller ID installed on your telephone line.
• If you pick up the phone before the second ring, the caller information
will not be correctly received. If you have telephone answering device
(TAD) connected with the unit, set the TAD to answer after two rings or
more.
• If it is a blocked call or an out-of-area call, the caller’s name and/or
phone number will not appear on the display.
• If only the caller’s phone number appears on the display, it may be
Single Data Message Format (SDMF) call, as opposed to a Multiple
Data Message Format (MDMF) call. Please call your local phone
company to see which service you have.
Random characters
and/or “NO DATA”
appear on the LCD
display
• On rare occasions, the Caller ID information sent by the telephone
company may have an error in the transmission. This is not the fault of
your Caller ID unit. It can only capture and store the data that was
received.
Cannot get call
Waiting identification
on the LCD panel
• Subscription to Caller ID Call Waiting (CIDCW) is required from your
local phone company for the CIDCW function to operate properly. Call
you local phone company for details.