User's Manual

SENTON Enterprises Limited 信 通 企 業 有 限 公 司
Flat 10, 17/F, Fo Tan Industrial Centre, 香港沙田火炭坳背灣街 26-28 號
26-28 Au Pui Wan Street, Fo Tan, Shatin, N.T., Hong Kong 富騰工業中心 17 樓 10 室
Tel: [phone] Fax: [phone] 電話: (八五二) 二六八七 一七一二 (四線)
E-mail address: [e-mail]
傳真: (八五二) 二六八七 四一二五
8 030206A-1
(Figure 1)
3. Insert the Ni-Cd battery into the battery compartment.
4. Replace the battery compartment cover by sliding it up towards the handset.
NOTE: Use the type and size of Ni-Cd battery pack, 3.6V, 450mAh. It is
recommended that the Ni-Cd battery pack should be fully charged overnight prior
to initial use.
Belt Clip Installation
With the back of handset facing up, insert one side of the belt clip hook into the matching slots at the top
side of handset as shown in Figure2. Slide the other hook until it locks into place from the opposite side
of the handset.
(Figure 2)
POWER CONNECTION
CAUTION: You must use a Class II, 220 Volt AC/9 Volt DC adaptor that delivers at
least 500mA for base unit and 200mA for charger. The center tip must be positive and the
plug must correctly fit the base unit’s DC 9V 500mA jack and fit the charger DC 9V
200mA jack.
1. Plug the AC adaptor into a standard AC outlet.
2. Insert the small plug into the DC 9V 500mA jack on the rear of the base unit and Insert the small
plug into the DC 9V 200mA on the rear of the charger as shown in Figure 3.
Handset
Battery
compartment
Red
wire
Black
Wire
Battery
Connector
Belt clip hook