User's Manual

112803A-1 11
OWNER’S MANUAL # 36122 ver. 112803A-1
Page: 11 ENGLISH VERSION
WALL USE:
Wall Mounting (Standard Wall Jack)
1. Install the wall mount bracket at the position as shown in Figure 3.
2. Connect the short telephone line cord to the TEL LINE jack..
3. Connect the opposite end of the telephone line cord to the modular wall jack.
4. Align the wall mounting slots with studs located on the modular wall plate and slide
base down to lock in place.
Wall Mounting (No Standard Wall Jack)
1. Drill two holes with a vertical distance between the two marked positions of 3
15/16”
( 100mm) as shown in Figure 4.
(Figure 4)
2. Drive a screw into each of the holes. Tighten them to the end of the screw lines, only
leaving the smooth part of the screw head outside the wall.
3. Hand the unit onto the screws, then slide it down firmly to fasten the base securely.
.....................
.....................
.
.
3 15/16 55
(100mm)
Base Unit
(Side View)
Wall Mount Bracket
Wall Mount
Stud
Telephone
Modular
Jack
Wall Mount
Stud
(Figure 3)