User's Manual

070203

A-1

OWNER’S MANUAL # 36287 ver. 070203A-1

Page: 13 ENGLISH VERSION

INITIAL SETUP

Please follow these steps before using the cordless telephone for the first time.

1. Ensure that the handset battery pack is installed and charged fully for at least 14 hours.

Ensure that all connections(line cord and adaptor cord) are properly inserted into rear

of the base unit.

SETTING THE TONE/PULSE MODE

Select the appropriate dialing service by moving the T/P(TONE/PULSE) switch at the rear of

the base unit:

· (T) TONE for Tone service , or

· (P) PULSE for Rotary service.

SETTING THE HANDSET RINGER ON/OFF MODE

The handset must be set to ring ON mode in order to ring when receiving an incoming call.

See Programs Operation section on page 25.

TELEPHONE OPERATION

Place a Call

1. Pick up the handset and press the TALK button. The Call Timer starts to count. The

base unit IN USE LED indicator will light up.

2. Listen for a dial tone.

3. Dial the telephone number. The phone numbers appear on the LCD Display as you

enter the number.

4. When finished with your call, press the TALK button or place the handset on the base

unit. The base IN USE LED indicator will turn off.

NOTE: The call timer will start to count once you press the TALK button.

Receive a Call

NOTE: If you are expecting incoming calls, the handset must be programmed to RING ON

mode.

If the handset is on the base:

1. When the phone rings, simply pick up the handset from the base cradle if the unit is set

to auto-answer ON mode. If the unit is set to auto-answer OFF mode, press the TALK

button. See page 28 to set auto-answer mode. The LCD Display will show “TALK”.

2. Start your conversation.

3. To end your conversation, either press the TALK button or place the handset on the

base unit. The base IN USE LED indicator will turn off.