Alarm Clock Radio MODEL CR105 Operating Instructions BEFORE OPERATING THIS PRODUCT, READ, UNDERSTAND, AND FOLLOW THESE INSTRUCTIONS. Be sure to save this booklet for future reference.
The exclamation point within with CAUTION: TO REDUCE THE RISK arrowhead symbol, with an OF ELECTRIC SHOCK, DO NOT equilateral REMOVE COVER (OR BACK). NO The Lightning flash triangle is intended to alert the user of USER SERVICEABLE the presence of uninsulated INSIDE. REFER dangerous voltage within the QUALIFIED SERVICE PERSONNEL.
5. Water and Moisture - The appliance should not be used near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool or the like. 6. Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling. 7. Ventilation - The appliance should be situated so that its location or position does not interfere with its proper ventilation.
c) If the product has been exposed to rain or water. d) If the product does not operate when used according to the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may interfere with the product’s normal operation. e) If the product has been dropped or damaged in any way. f) When the product exhibits a distinct change in performance-this indicates a need for service. 16.
NEC NATIONAL ELECTRICAL CODE Do not apply oil or petroleum products to this product. CAUTION Invisible laser radiation will be emitted when the product is open and interlocks are defeated. Do not defeat the safety interlocks. GRAPHIC SYMBOLS WITH SUPPLEMENTARY MARKINGS ARE LOCATED AT THE BACK OF THE UNIT. USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
IMPORTANT INFORMATION REQUIRED BY THE FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interference received, including interference that may cause undesirable operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
LOCATION OF CONTROLS: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18.
POWER CONNECTION Plug the AC POWER CORD to the household outlet. Make sure the voltage is correct for safety purpose and prevent plausible damages to the set. Connect one 9 volt battery (not included) to the battery terminals in the BATTERY COMPARTMENT. It maintains the clock function whenever the AC power is interrupted. REMARK: The time display will not exhibit during power failure. But the clock display will continue at the correct time once the main power supply is resumed. RADIO OPERATION 1.
selected preset alarm time, the buzzer will automatically turn on for 1 hour and 59 minutes and then shuts off. SWITCHING OFF THE ALARM 1. To switch off the alarm set, just press the ALARM SET/OFF BUTTON once and the alarm time will be reset for the next day. 2. Or slide the FUNCTION SWITCH to the “OFF” position to turn off the alarm (the alarm time will not be reset for the next day). SNOOZE OPERATION The alarm can be temporarily turned off manually by pressing the SNOOZE BUTTON.
press the ALARM SET/OFF BUTTON or slide the FUNCTION SWITCH to the “OFF” position. LED NIGHT LIGHT OPERATION z To set the LED night light to the desired level by sliding the LIGHT CONTROL. z To turn off the LED night light, slide the LIGHT CONTROL to “OFF” position until you hear the “click” sound.
