Installation Guide

Install Linear Actuator Cable

Withthecontrolboxinstalledroutethelinearactuatorcableintothebottomofthecontrolboxusing

the11/4”holeintherearbottom.Slidetheholeplugthatisinstalledonthelinearactuatorcableinto

thecontrolboxholeandsnapinplace.

Ifcablelengthisexcessive,coilupandplaceinthewirecompartmentofcontrolbox.

EnsurethelengthallowsforconnectiontotheSentrycontrolboardGate1connector.

Sentry Plug N Go Harness Final Installation

At this point verify the following items have been completed:

3 Linearactuatorinstallationiscomplete.

3 Controlboxissecurelyinstalled.

3 PlugNGoharnessisconnectedtothechargecontroller.

3 PlugNGoharnessisconnectedtothebattery.

3 Batteryisinstalledinthebatterycompartmentofcontrolbox.

3 Chargedevicecableisroutedintocontrolboxandconnectedtothechargecontroller.

3 Linearactuatorcableisroutedintocontrolbox.

Verify the above items have been completed correctly before continuing. If necessary, correct

before proceeding. If completed, procede with the following steps:

1. Locatethepowerconnectorattachedtothelinearactuatorcable(redandblackwires).

2. ConnectittooneofthePlugNGoharnesslinearactuatorpowerplugs.Theseconnectorsare

designedsothatincorrectconnectionisnotpossibleanditdoesnotmatterwhichconnectoris

used.

3. Locatethelinearactuatorcable8pinplug.

4. ConnectittotheGate1connectorlocatedontheSentryControlboard.

5. Securelysnapinplace.

6. Onceallconnectionsaremadeplacewiresinwirecompartment.

NOTE: In case of an emergency,theGate1orGate2connectorcanberemovedatanytimefrom

controlboardtostopgatefrommoving.

This completes all cable connections and cable routing into

the control box.