Installation Guide

33
Usetablebelowtocreateyourrandomsecuritycodeandfollowstepsbelowtoprogramyourkeypad.
Dipswitch
Position
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
Switch
9
#
0
*
1. Enter the Master Password.
2. Enter“6”Ifcorrect,2shortbeeps(if1longbeepisheard,startoverwithstep1).
3. EntertheSecurityCodecreatedintheprevioustable.Ifcorrect,2shortbeepsaftereach
switchnumberandswitchpositioncombinationisentered.
4. Enter“#”
5. Enter“6”
6. Ifcorrect,2shortbeeps(if1longbeepisheard,startoverwithstep1).
Learning Access Codes in Receiver:
Create Communication with Receiver Relay 1:
1. Carrykeypadtoreceiverlocationforprogramming.
2. EntertheAccessCodeforrelay1onthekeypadandcontinuetopressthelastkeyentered
(redlightblinks).
3. PressP1(learnbutton)onthereceiveruntilLD(greenlight)comesonandrelayclicks.
Create Communication with Receiver Relay 2:
1. Carrykeypadtoreceiverlocationforprogramming.
2. EntertheAccessCodeforrelay2onthekeypadandcontinuetopressthelastkeyentered(red
lightblinks).
3. PressP2(learnbutton)onthereceiveruntilLD(greenlight)comesonandrelayclicks.
Deleting Single Access Code:
1. Enter the Master Password.
2. Pressthe“7”key.Ifcorrect,2shortbeeps(if 1 long beep is heard, start over with step 1).
3. EntertheAccessCodetobedeleted.
4. Pressthe“7”key.
5. ReentertheAccessCodetobedeleted.
6. Pressthe“7”key.Ifcorrect,2shortbeeps(if 1 long beep is heard, start over with step 1).
Deleting All Access Codes:
1. Enter the Master Password.
2. Pressthe“7”key.Ifcorrect,2shortbeeps(if 1 long beep is heard, start over with step 1).
3. Reenter the Master Password.
4. Pressthe“7”key.
5. Reenter the Master Password.
6. Pressthe“7”key.Ifcorrect,2shortbeeps(if 1 long beep is heard, start over with step 1).