Installation Guide

6
Transmitter
Part#030210
2 per
Transformer
Part#520008
1 per
Charge Controller
Part#520007
1 per (Installed)
LCR Receiver
Part#030200
1 per (Installed)
Control Board
Part#500410
1 per (Installed)
Charge Controller
LCR Receiver
3/8 x 16 nylon lock nut
Part#610518
5 per
1/4 x 20 nylon lock nut
Part#610526
2 per
3/8 USS at washer
Part#610514
6 per
3/8 SAE at washer
Part#610516
2 per
1/4 SAE at washer
Part#610524
4 per
Nylon washer
Part#610528
2per
3/8 x 2 1/2” shoulder bolt
Part#610512
3per
3/8 x 16 x 8” carriage bolt
Part#610510
2per
Tap bolt
1/4 x 20 x 3 1/2”
Part#610522
2per
Tap bolt
1/4 x 20 x 2 1/2”
Part#610520
2per
#12 x 1 1/4 self tap hex screw
Part # 610532
4 per
GENERAL TOOL REQUIREMENTS
Tools required for most installations:
 •Wrenches–7/16,9/16and10mm •Sockets7/16,3/8and5/16
 •Drill •Drillbits1/4and3/8inch
 •Drilladapterforsocketattachment •Pliers
 •Hacksaw •Levelandtapemeasure
Weldingistherecommendedmethodofsecuringthelinearactuatormountstothegateandhingepost.
Boltonbracketsareprovidedandareacceptablebutmayrequirefrequentservicetokeeptight.They
mustbeverysecurelyattached(i.e.carriageboltswithlocknutsandwashers).Lagtypeboltsarenot
recommended.Looseorunstablelinearactuatormountswillresultinimproperoperation.
IMPORTANT CAUTIONS:
1. Donotperformanyweldingwiththeactuatorcablepluggedintothecontrolboardorthebattery
connected.Seriousdamagetothecontrolboardand/orbatterymayoccurifattempted.
2. Usecontrolboxasatemplatetodeterminemountingscrewlocationsandthenattachscrews
andslideoncontrolbox.Donotattempttoholdcontrolboxanddrillmountingholes.Thiscould
damagethepreinstalledcomponents.
3. AlwaysdisconnectthebatterypowerfromthecontrolboardusingthePlugNGoharnesspriorto
wiringanydevicestothecontrolboard.
HARDWARE INVENTORY