User manual

12
REMOTEUNLOCK

ThedefaultRelayHold&ReleaseCodeis5678.

1) UseyourcellphonetodialintothesystembyenteringthephonenumberoftheSIMCardinstalledinthesystem.Thesystemwillthen
verifyyourphonenumberwiththepredefinednumbers.Youwillhearalongtonewhenthedoorsystemanswersthecall.

2) To
haveAdminCallintoUnlock:
Momentary(TriggerRelay),enter:
33  #
Admincancallintothesystemtounlockthedooronlyonce.

3) TohaveAdminCallintoUnlock:
Unlimited(RelayHold),enter: 
34  #
Admincancallintothesystemtounlockthedoormorethanonce–unlimited.

4) TohaveAdminCallintoLock
(RelayRelease),enter:   35  #
Admincancallintothesystemtolockthedoor.



ADJUSTMENTS

ToadjustSpeakerVolume,enter:   12 1234#3x#
Volumelevelx=1,2,3,4where1=lowand4=high.Thedefaultissettolevel3.

ToadjustMicVolume,enter:   12 1234#4x#
Volumelevelx=1,2,3,4where1=lowand4=high.Thedefaultissettolevel3.

ToadjustsystemOpenTime,enter:   12
1234#51x#
Theopentimeishowlongthedoorstaysunlockedafterbeingactivated.Thedefaultis8seconds.
x=timeinseconds(1‐9)

ToadjustRingDivertTime,enter:   12 1234#52xx#
TheringdiverttimeishowlongthephonecallstaysringingbeforedivertingtothenextAdmin.Thedefaultis18seconds.
xx=10‐99seconds

ToadjustCall/TalkTime,enter:   12 1234#53xxx#
Call/talktimeishowlongthephonestaysconnectedbeforehangingup.Thedefaultis55seconds.
xxx=005‐999seconds



OTHERPROGRAMMINGKEYCODES

LISTALLNUMBERSSTOREDINSYSTEM
ThePowerAdminisabletoreceiveanSMStextwithalistofallthephonenumbersstoredinthesystem.

ToListallPhoneNumbers
storedinthesystem,enter: 21#


CHECKSTATUS
TochecktheLock(Relay)Status,enter: 22#
Relayon=unlocked;Relayoff=locked
Detect=on/off

TocheckGSMSignalStatus,enter:  
20#
WhenarequestforGSMsignalstrengthmessageissenttothesystem,itwillsendaSMSreplywithonedigitsignalstrengthcodebetween0~4.
Signalstrengthlowerthanlevel3maycauseoperationalproblemssuchaslossofspeechquality(andpossiblymissingDTMFtones)and
network
loss.
x=0‐4,0beingthelowestand4beingthehighest