Operation Manual

11
English
Bolting Down Your Safe
WARNING
DONOTdrillthroughboltcups.
WARNING
DONOTboltthroughthewalls.
WARNING
DoNOTdrillfromanylocationinsidethesafe.
Bolt down kit contents (in select models only):
2lagscrews
2washers
2masonryanchors
Tools needed to bolt safe to the floor:
Drill
Wrench
7⁄16"(11mm)drillbit–fordrillingintothesafe
9⁄32"(7.2mm)drillbit–fordrillingintoawoodoor
3⁄8"(9.5mm)drillbit–fordrillingintoamasonryoor
1
 Closethedoor.Tipthesafeontoitsleftside(doorhingeshorizontalwiththeoor).
Looktothebottomofthesafefortwoindentationsonthefeet
inoppositecorners.Usingthe7⁄16"(11mm)bit,drillahole
through each indentation perpendicular to the bottom of the
safe. DO NOT drill from any location inside the safe.
3
Tip the safe upright, place the safe in the desired location and open the door.
Useascreworpenciltomarktheoorthroughbothholes.
For products that do not come with bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Bolt down instructions
F
F
2
4
321165_FireSafeManual.indd 11 12/12/11 2:11 PM