Operation Manual

12
Bolting Down Your Safe
 Movethesafeasidetoclearbothmarkedspotsfordrilling.
A
For wood:Usingthe9⁄32"(7.2mm)drillbit,drillahole
2-1⁄2"(64mm)deepineachmarkedspot.
B
For masonry:Usingthe3⁄8"(9.5mm)drillbit,drilla
hole2-1⁄2"(64mm)deepineachmarkedspot.Installa
masonry anchor in each hole.
7
 Replacethesafeinthedesiredpositionwiththeholesinthesafealignedwiththose
in the floor.
Securing the safe:
A
For wood: Pass each lag screw through a washer, then
through the safe and into a hole. Tighten with a wrench.
B
For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor. Tighten
with a wrench. Place masonry anchors into the holes
in the floor.
NOTE: The safe should not be bolted to a wall, this will compromise the fire rating.
Drillholesthroughthefeetonly.Donotdrillthroughthebackorsides.
NOTE: Bolting/unboltingtheunitisataconsumer’sexpenseanddiscretion.
NOTE: Sentry Group is not responsible for any cost incurred if the unit has to be replaced.
For products that do not come with bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Bolt down instructions… continued
5
F
6
8
F
F
321165_FireSafeManual.indd 12 12/12/11 2:11 PM