Operation Manual

6
Programmable Electronic Lock
Three code options:
FACTORY CODE:
ThesafewillALWAYSunlockusingthis5-digitcode(foundonthebackoftheowner’smanual).
This code cannot be deleted.
USER CODE:
A5-digitprogrammablecodeofyourchoosingthatcanbechangedordeleted.
SECONDARY CODE:
A5-digitprogrammablecodeofyourchoosingthatcanbechangedordeleted.Canonly
be programmed after a user code has been activated.
NOTE: The“C”keyisaclearkey.Thiscanbeusedatanytimetoclearthesystemandreturn
to standby mode – unless you are in delay mode (3 consecutive invalid entries).
NOTE: Onlyoneusercodecanbeprogrammedatatime.
ToADDausercode:
1
 Pressthe“P”key.
2
 Enterthe5-digitfactorycode.
3
The light will flash green and then you will have five
secondstoenteryourown5-digitpersonalusercode.
ToDELETEausercode:
1
 Pressthe“P”key.
2
 Enterthe5-digitfactorycode.
3
 Enter0,0,0,0,0.
NOTE: TheelectroniclockwillNOTindicatethatithasdeletedtheusercode–pleasetest
thecodetomakesureithasbeendeleted.
Programming information
Programming the user code
321165_FireSafeManual.indd 6 12/12/11 2:11 PM