Operating Guide

11
English
Bolting Down Your Safe
Bolt-down instructions
NOTICE
Product is not water resistant once it is bolted down. The ETL verified water resis-
tance claim applies to product prior to the application of a bolt-down kit.
Bolt-down kit contents (in select models only):
• 2 lag screws
• 2 washers
• 2 masonry anchors
Tools needed to bolt safe to the floor:
• Drill
• Wrench
•
7
⁄
16
” (11 mm) drill bit – for drilling into the safe
•
9
⁄
32
” (7.2 mm) drill bit – for drilling into a wood floor
•
3
⁄
8
” (9.5 mm) drill bit – for drilling into a masonry floor
Warning: • DO NOT drill from any location inside the safe.
• DO NOT bolt through the walls.
1
Tip the safe onto its right side (door hinges horizontal with the floor).
2
Unlock the safe and open the door. Look to the bottom of the
safe for two indentations on the feet in opposite corners. Using
the
7
⁄
16
” (11 mm) bit; drill a hole through each indentation
perpendicular to the bottom of the safe. DO NOT drill from
any location inside the safe.
3
Tip the safe upright, place the safe in the desired location and open the door.
4
Use a screw or pencil to mark the floor through both holes.
F
F