Troubleshooting guide
Table Of Contents
- Maintenance Overview
- DVR Status Check and Camera Alignment – 5 Minute Test
- Adjusting the Date and Time
- Setting the Time and Date Manually
- Setting the Time and Date using GPS
- Changing Fan Filters
- Checking the DVR condition & mounting
- Connecting a Laptop to DVR via Ethernet Cable
- Connecting the DVR to the Computer
- Updating the DVR Firmware
- Reformatting Hard Drives
- Removing the Hard Drive
- Replacing the Hard Drive
- Cleaning the Dome or Wedge Camera Window
- Cleaning the DVR front cover and cable cover
- Troubleshooting Overview
Seon Maintenance and Troubleshooting Guide R004 46
TR-INR External Inertia/G Sensor
Inertia Sensor not giving
readings
1. Check the cable running between the DVR or SMART LINK IFM and the Inertia
Sensor. Ensure that it is firmly and properly connected to the inertia Sensor; Also
make sure that the connector on the opposite end of the cable is plugged into the
DVR (Trooper Models) or IFM (Explorer Model’s Only). Ensure that the Red and Black
wires are intact in the connector plug.
2.
Check for broken or damaged wires
Check for bent or broken pins in the connector to the Inertia Sensor
Check connector housing to ensure that it is not cracked or broken
Check for physical signs of damage to the Inertia sensor itself. IE. Burnt out LED;
Damaged or broken buttons, cracked or broken housing and glass etc.
Check to ensure that there is no evidence of water damage to either the
connector pins or the Inertia Sensor itself.