Data Sheet
Table Of Contents
- 1. Revision History
- 2. Scope
- 3. Product Information
- 4. Introduction
- 5. Electrical Specifications
- 5-1. Absolute Maximum Ratings
- 5-2. Recommended operating Range
- 5-3. Electrical Characteristics – DC
- 5-4. Electrical Characteristics – RF TX
- 5-5. Electrical Characteristics – RF RX
- 5-6. Electrical Characteristics – RF PLL
- 5-7. Electrical Characteristics – Audio C/CS
- 5-8. AV5100 Rate Converter Characteristics
- 5-9. I2S Communication Interface Timing
- 5-10. I2C Slave Communication Interface Timing
- 6. I/O Connector Pin Description
- 7. Mechanical Specifications
- 7-1. Module dimension
- 7-2. Antenna dimension
- 8. Label Specification
- 9. Certificate Statement
PBA RF Module ATM210
5GHz
Wireless Audio Transceiver
REV: 00
9. Certificate Statement
FCC & IC Statement
This AUDIO TRANSCEIVER has been granted modular approval for mobile applications. OEM integrators for host
products may use the module in their final products without additional FCC / IC (Industry Canada) certification if they
meet the following conditions. Otherwise, additional FCC / IC approvals must be obtained.
• The host product with the module installed must be evaluated for simultaneous transmission requirements.
• The user’s manual for the host product must clearly indicate the operating requirements and conditions that
must be observed to ensure compliance with current FCC / IC RF exposure guidelines.
• To comply with FCC / IC regulations limiting both maximum RF output power and human exposure to RF
radiation, use this module only with the included onboard antenna.
• A label must be affixed to the outside of the host product with the following statements:
Product Name : AUDIO TRANSCEIVER
Contains FCC ID:
2AS8LATM210
Contains IC:
25119-ATM210
The final host / module combination may also need to be evaluated against the FCC Part 15B criteria for unintentional
radiators in order to be properly authorized for operation as a Part 15 digital device.
This equipment has been tested and found to comply within the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a different circuit from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
17 /20
JUN 10,2019