Data Sheet
Table Of Contents
- 1. Revision History
- 2. Scope
- 3. Product Information
- 4. Introduction
- 5. Electrical Specifications
- 5-1. Absolute Maximum Ratings
- 5-2. Recommended operating Range
- 5-3. Electrical Characteristics – DC
- 5-4. Electrical Characteristics – RF TX
- 5-5. Electrical Characteristics – RF RX
- 5-6. Electrical Characteristics – RF PLL
- 5-7. Electrical Characteristics – Audio C/CS
- 5-8. AV5100 Rate Converter Characteristics
- 5-9. I2S Communication Interface Timing
- 5-10. I2C Slave Communication Interface Timing
- 6. I/O Connector Pin Description
- 7. Mechanical Specifications
- 7-1. Module dimension
- 7-2. Antenna dimension
- 8. Label Specification
- 9. Certificate Statement
PBA RF Module ATM210
5GHz
Wireless Audio Transceiver
REV: 00
OEM Instruction Manual Content
Consistent with §2.909(a), the following text must be included within the user’s manual or operator instruction guide
for the final commercial product (OEM-specific content is displayed in italics.)
Operating Requirements and Conditions:
The design of ATM210 complies with U.S. Federal Communications Commission (FCC) guidelines respecting
safety levels of radio frequency (RF) exposure for Mobile devices.
Note: In the case where the Host / Module combination has been re-certified the FCCID shall appear in the product
manual as follows:
FCCID:
2AS8LATM 210
Mobile Device RF Exposure Statement (If Applicable):
RF Exposure - This device is only authorized for use in a mobile application. At least 20 cm of separation distance
between the transmitting antenna device and the user's body must be maintained at all times.
Caution Statement for Modifications:
Caution: Any changes or modifications to the equipment not expressly approved by the party responsible for
compliance could void user s authority to operate the equipment.
FCC Part 15 Statement (Only Include if FCC Part 15 is Required on the End Product):
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. (OEM must follow Part 15 guidelines (§15.105 and §15.19) to determine additional statements
required in this section for their device class)
Note 2 : This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions.
1) This device may not cause harmful interference, and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
a. That module is limited to OEM installation ONLY.
b. That OEM integrators are responsible for ensuring that the end-user has no manual instructions to remove or install
module.
c. That module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).
d. That separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
e. That grantee shall provide guidance to the host manufacturer for compliance with Part 15 subpart B requirements.
19 /20
JUN 10,2019