User's Manual

3.3 Windows XP Setup

- To run the Command Prompt, click the Start button on the lower left corner of Windows screen and click

Run to enter “cmd” in the Open box, and then click OK button.

- When the Command Prompt runs, enter the “ipconfig” command to verify IP address, Subnet mask, and

Gateway, which are automatically assigned to PC.

[Note] All PCs connected to VoIP CPE will get each of assigned IP addresses respectively.

IP Address: 192.168.1. 100~150

Subnet Mask: 255.255.255.0

Default Gateway: 192.168.1.1

[Note] If IP address is not assigned normally, check the following and restart PC so as to check

if the IP address is assigned.

- LAN cable connection between PC and VoIP CPE

- Check TCP/IP setup details