User Guide

40
STP8X series safety and compliance
THE STP8X RADIO MUST NOT BE USED IN ENVIRONMENTS EXCEEDING
THOSE LISTED ON THE PRODUCT TECHNICAL DATA SHEET.
Product certification
Intrinsic Safety Certification numbers:
IECEx: BAS 12.0001X
ATEX: Baseefa 12ATEX0002X
Additional in country intrinsic
safety certificates: Standards:
Brazil: IEx 12.0081x IEC 60079-0:2011, Edition 6.0
Belarus: RU C-GB.ГБ08.B00080 IEC 60079-11:2011, Edition 6.0
Kazakhstan: RU C-GB.ГБ08.B00080 EN 60079-11:2012
EN 60079-0:2012 + A11:2013
International IECEx Specifications:
Gas Environment: Ex ib IIC T4 Gb (-20°C<=Ta<=+55°C)
Dust Environment: Ex ib IIIC T90°C Db (-20°C<=Ta<=+55°C)
European ATEX Specifications :
Gas Environment: II 2G Ex ib IIC T4 Gb (-20°C<=Ta<=+55°C)
Dust Environment: II 2D Ex ib IIIC T90°C Db (-20°C<=Ta<=+55°C)
STP8X Conditions for Safe Use
Please observe these additional safety instructions for the STP8X radios.
A Sepura approved intrinsically safe ATEX/IECEx battery, accessory and antenna
must be used with the STP8x series radios. The use of non-approved batteries,
accessories and antennas may damage the product and will result in the non-
compliance with regulatory requirements and product safety ratings.
NEVER fit or remove the antenna, battery, Smart/microSD card or an accessory
when operating in a hazardous environment.
NEVER operate your radio without the RuSC cover fitted when an accessory is
not fitted. When attaching the RuSC cover, tighten the screw to 0.15 Nm. When
attaching an accessory, tighten the screw to 0.25 Nm to ensure that the seal is
maintained between your radio and the accessory.
Ensure that the seal between the antenna and your radio is maintained. To secure
the antenna, rotate the antenna until it is finger tight, then apply another 1/4 turn.
If a Smart/microSD card is fitted, ensure that the compartment cover is secure.
Tighten the screw to 0.1 Nm (pinch tight).
STP8X
95128 Health and Safety Guide (SPR DOC-00170)_95128 Health and Safety Guide (SPR DOC