User's Guide

Radios can be customised either in bulk, by fitting them into a Sepura programming pod which can
accommodate 4 or 8 radios at a time, or individually by directly connecting them to a computer
running Radio Manager 2 software using a Sepura Data/Programming Cable.
Your radio must be powered on and have sufficient battery charge for the duration of the
customisation process.
Your radio cannot be programmed when Connector Protector on page96 is enabled.
To program a single radio
A data/programming cable, with either an RS232 (D-type) connector or a USB connector, is
available from Sepura for customising a single radio.
A data/programming cable, with either an RS232 (D-type) connector or a USB connector, is
available from Sepura for customising a single radio.
1. Connect the USBprogramming cable to the computer.
2.
Connect the cable to the radio by inserting the hook on the connector into the slot as shown.
3.
Secure the cable in position. Do not over tighten.
4. When programming is complete disconnect the cable from the radio.
Revert radio settings to customisation settings
Users have the ability to add personal data to the radio, such as adding contacts to the phonebook,
changing the talkgroups and sending and receiving SDS/Status messages. Such changes may be
undesirable on fleet radios that have been specifically customised for fleet users—where radios are
not personal processions. Using the Revert All Changes option, the radio settings can be reset
back to the last customisation settings.
120 SC20 Series hand-portable radio