User's Guide

Fitting a Smartcard
If required by your network operator, you may need to fit a Smartcard to your radio.
1. Lift the compartment cover using a small screw driver or tweezers. The cover is secured by
two tabs located at the top of the cover, either side of the recess.
2. Insert the card into the slot on the underside of the cover as shown, ensuring that the card is
secured between the two tabs.
3. Close the cover. Using your thumbs, press downward firmly on either side of the cover as
shown to secure each tab. You must ensure that the compartment cover is secured. Not
securing the cover will affect your radio's IP rating.
Caution! Risk of damage to the radio. Do not attempt to remove the card holder cover by
levering along the sealed edges with tooling. The cover must be refitted correctly to retain the
radio's IP rating.
Caution! Risk of damage to the radio. Do not over-extend the card holder in the open
position as this can cause permanent damage.
18 SC20 Series hand-portable radio