User's Guide

Data devices
You can pair your radio with data devices such as a laptop or PDA. When you pair to a data device it
'discovers' your radio.
To pair with an incoming data device:
1.
Press Menu then select Options > Bluetooth > Devices.
2.
Select Discoverable.
If your radio has been customised not to allow any incoming pairing operations ‘Cannot Add
Device’ is displayed on the Devices screen.
3. If you are prompted to enter an Access Code, enter it as described in PIN entry on page112.
If you enter an incorrect Access Code an error message and a large cross are displayed and it
will not be possible to pair any devices with the radio.
4.
The Terminal Visible Passcode appears if a random passcode is configured or the message
“Terminal Visible” appears if a fixed passcode is configured.
5.
The method of pairing the devices will depend on the Bluetooth® capability of the connecting
device. If the connecting device support SSP, the device may automatically pair with the radio.
Alternatively the device generates a random 6 digit PIN that is matched to a generated code
on the radio. Press OK to confirm the match and pair the devices. If the connecting device
does not support SSP, the device will prompt to enter a passcode manually. Enter the random
passcode shown by the radio onto the device or a fixed passcode already given.
6.
When the pairing is successful, the radio will display confirmation that the pairing is successful.
7. On your radio press Accept to confirm the request and to connect with the device.
A message is displayed to confirm the pairing and the device is listed in the list of paired devices.
(You can also Modify the device list, see Modify connected devices on the next page.
Tip! If customised to do so, your radio will automatically connect to a ‘trusted’ device—the
data device that was most recently connected to the radio—whenever requested to do so
unless you explicitly disconnected it by pressing Disconn. In this case to reconnect the
radio and the data device press Connect.
To connect with an outgoing data device:
You can search for—and then pair—your radio with data devices you discover.
1.
Press Menu then select Options > Bluetooth > Devices.
2. Select Search.Search is prevented if the Bluetooth® is switched off or if the maximum
number of devices (ten) have already been paired.
3.
If you are prompted to enter an Access Code, enter it as described in PIN entry on page112.
If you enter an incorrect Access Code an error message and a large cross are displayed and it
will not be possible to pair any devices with the radio. Correct Access Codes are valid until the
User Guide 109