User Guide

31
STP8X series safety and compliance
THE STP8X RADIO MUST NOT BE USED IN ENVIRONMENTS EXCEEDING THOSE LISTED
ON THE PRODUCT TECHNICAL DATA SHEET.
Product certification
Intrinsic Safety Certification numbers:
IECEx: BAS 12.0001X
ATEX: Baseefa 12ATEX0002X
Additional in country intrinsic safety certificates:
Brazil: IEx 13.0081X
Russia: C-GB.HA65.B.00035/19
International IECEx Specifications:
Gas Environment: Ex ib IIC T4 Gb (-20°C<=Ta<=+55°C)
Dust Environment: Ex ib IIIC T90°C Db (-20°C<=Ta<=+55°C)
European ATEX Specifications :
Gas Environment: II 2G Ex ib IIC T4 Gb (-20°C<=Ta<=+55°C)
Dust Environment: II 2D Ex ib IIIC T90°C Db (-20°C<=Ta<=+55°C)
STP8X conditions for safe use
Please observe these additional safety instructions for the STP8X radios.
A Sepura approved intrinsically safe ATEX/IECEx battery, accessory and antenna must be used with the
STP8x series radios. The use of non-approved batteries, accessories and antennas may damage the
product and will result in the non-compliance with regulatory requirements and product safety ratings.
NEVER fit or remove the antenna, battery, Smart/microSD card or an accessory when operating in a
hazardous environment.
NEVER operate your radio without the RuSC cover fitted when an accessory is not fitted. When attaching
the RuSC cover, tighten the screw to 0.15 Nm. When attaching an accessory, tighten the screw to 0.25
Nm to ensure that the seal is maintained between your radio and the accessory.
Ensure that the seal between the antenna and your radio is maintained. To secure the antenna, rotate
the antenna until it is finger tight, then apply another 1/4 turn.
If a Smart/microSD card is fitted, ensure that the compartment cover is secure. Tighten the screw to 0.1
Nm (pinch tight).
Sicherheit und Vorschriftsmäßigkeit der STP8X-Baureihe
DAS FUNKGERÄT STP8X DARF NICHT IN EINER UMGEBUNG EINGESETZT WERDEN,
DEREN BEDINGUNGEN NICHT DEN IM TECHNISCHEN DATENBLATT GENANNTEN
ANFORDERUNGEN ENTSPRECHEN.
Produktzertifizierung
Eigensicherheits-Zertifizierungsnummern:
IECEx: BAS 12.0001X
ATEX: Baseefa 12ATEX0002X
Zusätzliche nationale Eigensicherheits Zertifizierungsnummern:
Brasilien: IEx 13.0081X
Russland: C-GB.HA65.B.00035/19
STP8X