User's Guide

Press Menu then select Options > Bluetooth > ON/OFF.
When Bluetooth is switched on but no devices are connected the Bluetooth icon is displayed.
The radio’s Bluetooth name, which is visible on data devices when they attempt to ‘pair’ with your
radio, is shown on the screen.
Audio devices
You can search for and pair an audio device with your radio or view which devices have already been
paired from the Devices screen. Once paired it is possible to connect to or disconnect from a
Bluetooth® device while a call is in progress either using the Bluetooth® menu screens or a soft key
(disconnection only) if customised. It is also possible to connect to a headset by pressing the button
on the headset.
Tip! Before attempting to pair, check that the audio device is powered on, is set to the
discoverable (visible) state and is close to your radio before attempting a new search. If
several devices are available it is advisable to power off any which are not required and set
only the required device into the discoverable (visible) state.
Connect with audio devices:
1.
Press Menu then select Options > Bluetooth > Devices. or press a customised soft key to
initiate pairing with a device.
2. Select Search.(Search is prevented if the Bluetooth® is switched off or if the maximum
number of devices (ten) have already been paired.)
3.
If you are prompted to enter an Access Code, enter it as described in PIN entry on page112.
If you enter an incorrect Access Code an error message and a large cross are displayed and it
will not be possible to pair any devices with the radio. Correct Access Codes are valid until the
radio is powerswitched off.
During searching a ‘Searching’ message is displayed and any data devices found are listed.
The search stops when all available data devices have been found up to the maximum of ten,
and a ‘Search Complete’ message is displayed. If no devices are found a warning message
‘No Devices Found’ is displayed. To stop the search early and keep any devices found, press
Stop. (Press Cancel to abandon searching and delete any devices found.)
Tip! If a device is not found, check that the data device is powerswitched on, is set to
the discoverable (visible) state and is close enough to your Sepura radio before
attempting a new search.
Any audio devices found are listed on the screen as they are found. Audio devices which may
be worn on the body show the headset icon and non-wearable audio devices such as a
car kit or similar device show the car icon. The most recently found device is listed at the
top and is highlighted in blue.
User Guide 107