User's Manual

Quick Reference Guide
11
Charging your battery
If the battery is new, it is important that it is fully charged before
first use.
Your terminal will sound an audible alert when the battery has
less than 15% charge remaining.
Typical charging time is approximately 3-4 hours. This may vary
depending on the battery and environmental conditions.
Charge your battery between 5
o
C to 35
o
C (41
o
F to 95
o
F)
temperatures only.
Always ensure that the terminal is switched off before charging
the battery.
The charger must be placed onto a flat surface away from
flammable materials when charging.
Place the terminal with battery attached or battery separately
into the charger pocket by aligning the slots on the battery with
the guides on the charger pocket. Ensure the terminal or battery
is secure in the charger pocket.
Never leave the terminal or battery in the charger when not
charging.
The charger unit has LEDs that indicate the state of charging.
Charger LED
State
Solid red
Battery is charging
Solid green
Battery is fully charged. Standby mode
without battery
Flashing yellow
Battery is damaged. Contact your Service
Provider
Accessory information
Sepura supply a range of accessories for this product. Contact
your Service Provider or visit our website for a full list of
accessories:
http://www.sepura.com/products/terminals/accessories/dmr-
accessories.aspx
Attaching the battery
Align the battery with the two slots on the back of the terminal.
Carefully slide the battery forward along the slots until it clicks
into place.
Removing the battery
Ensure the terminal is switched off.
Press the battery latch in an upwards direction (1) and then slide
the battery backwards (2) until it detaches from the terminal.