User's Manual

12 DMR Repeater SBR8000, SCR8000, SER8000
Alarm mode
The Alarm indicator on the front panel illuminates when certain
operational states warrant. When the repeater is in start-up
mode, the LED remains illuminated for the duration of the start-
up routine (approx. 60 seconds).
LED state
Alarm condition
Illuminated for more
than 60 seconds
The internal temperature exceeds
the working limits.
or
Rx and Tx PLL (Phased Lock Loop)
have failed.
or
Tx VSWR (Voltage Standing Wave
Ratio) is incorrect.
Flashing once every
second
Rx PLL failure.
Flashing every two
seconds
Tx PLL failure.
Configuring the Repeater
The repeater is configured using the DMR Manager software
run from a computer connected directly to the repeater or over a
network.
Connect a standard LAN/WAN cable (RJ45 connector) to the
Network connector on the repeater with the other end
connected to either a computer or network connection.
The default IP address for the repeater is 192.168.1.100. This
address can be changed using the programming software.
Caring for your product
The product does not require regular servicing. Caring for your
product as described in this guide will help maintain the
product in good operational condition.
Always wear eye protection when using brushes or other tools
to clear debris from connectors or other parts of the product.
Do not use chemicals, aerosols or abrasive cleaners. Chemical
coatings must not be applied to any part of the product.
Clean the exterior surfaces using a lint free soft cloth.
Check cable connections regularly to ensure that they are secure.