Specifications

SB-P-06-4066
sepura
Mobile & Gateway Accessory i/f
specification
30th July 2012
Page 33 of 39
Issue 7c
© Sepura plc 2011
DATA CONNECTOR INTERFACE
A single Data Interface Connector is located on:
 The lower surface of the Console.
 On the outside of the AIU.
CONNECTOR DETAILS
Connector Type: 15 way high density female D type. Type JST KSEY-15S-1A3F19-13
SIGNAL DETAILS
Pin
Signal Name
Signal Function
Signal Function &
Signal Characteristics
1
AODO
1
/MIS
O
Console Programming &
Programmable I/O -Output
Open drain, active low.
500mA max sink current
15.8V max external voltage
Protected against inductive loads.
An external 10 kΩ pull-up resistor to 5V is
required for console programming. See {1} for
details
V
OL
max = 300mV
2
MOSI
Console Programming -
Input
5V logic. See {1} for details.
3
nReset
Console Programming - Input
5V logic. See {1} for details.
4
SCK
Console Programming - Input
5V logic. See {1} for details.
5
5V
Console Programming -
Output
5V nominal, 10mA max.
Not protected against misuse.
6
AGPI_1
1
Programmable I/O - Input
V
IH
min = 2.0V
11 12 13 14 15
1 2 3 4 5
6 7 8 9 10