Specifications

SB-P-06-4066

sepura

Mobile & Gateway Accessory i/f

specification

30th July 2012

Page 38 of 39

Issue 7c

Notes:

The complete overall length of cable for any accessory including any extension leads must

not exceed 3000mm.

Longer cable lengths will require Sepura to obtain further approvals before the

accessory may be used, the costs re-approval will be borne by the accessory

designer/manufacturer.

In order for the accessory to achieve the required conformity, it is recommended that the

cable be overall screened and Mic signals to be additionally screened.

To avoid shorting any exposed length of overall drain and microphone screen must be

sleeved with a tight fitting heat shrink to achieve a shrunk-down diameter of approximately

1mm to fit into the insulation crimp of the Hirose pins.

CABLE FORM GROMMET

Tolerance: linear dimensions ± 0.1mm, angles ± 1º

Projection: 3

angle

Fixing method: moulded onto cable.

Material: polyurethane type 58300, shore hardness 80A, colour black.

Pull force: Grommets to withstand a minimum pull force of 100N.

Tooling: Sepura Development to approve gate position prior to tool manufacture.

Surface finish: polished