Specifications

SB-P-06-4066

sepura

Mobile & Gateway Accessory i/f

specification

30th July 2012

Page 8 of 39

Issue 7c

DECLARATION OF CONFORMITY

Sepura mobile terminals and approved accessories are compliant with the essential

requirements of the 1999/05/EC Radio and Telecommunications Terminal Equipment

(R&TTE) Directive. The mobile variants and accessories are specified in the Declaration of

Conformity number DC/C 02001-3.

A copy of the declaration is available from Sepura on request.

As such, Sepura mobile terminals are compliant with the following mandatory specifications:

Safety to relevant parts of EN 60950 (Safety of Information Technology Equipment). This

includes the Low Voltage Directive (LVD);

Electromagnetic Compatibility (EMC) to relevant parts of EN 301 489 (Electromagnetic

Compatibility & Radio Spectrum Matters);

TETRA air interface to EN 303 035 (Terrestrial Trunked Radio (TETRA); Harmonized EN for

TETRA equipment covering essential requirements under article 3.2 of the R&TTE Directive);

In addition, Sepura mobile terminals and Third Party Accessory must also maintain

conformance in the following areas:

Dust & moisture protection to IP54 or greater to meet the needs of the user environment and

the relevant parts of ETS 300-019; CEN1789:2000

Protection against Acoustic Shock to relevant parts of ITU P.360. Sepura mobile terminals

comply with the maximum audio levels specified for Longer Duration disturbances.

The performance of the mobile must not be compromised by the r.f. field generated by the

mobile interfering with the accessory (different versions of Sepura mobile terminals operate

over frequencies within the range 350 MHz to 900 MHz and generate signals complying with

TETRA standards).

For example no audio interference should occur when a TETRA portable transmitting at 1 W

r.f. power, at frequencies between 300 MHz and 900 MHz, is held within 1cm of the

accessory.

The product shall not degrade the performance of a SRM/G 3500/3900 installation when

tested to TETRA EMC spec. EN 301489-1&18 V1.6.1 (2005-09) Including Annex B.

The combination of the accessory and the mobile must be ―fit for purpose‖. The use of an

accessory must not make the mobile difficult or awkward to use, or in any way degrade its

performance.

It is most important that any accessory designed for use with Sepura mobile

terminals does not affect any of the current approvals