Data Sheet
Table Of Contents
- Datasheet
- Preface
- About this Datasheet
- Product Features
- Regulatory Approval
- Physical Characteristics
- 3.1 ECCN and Part Number
- 3.2 Electrical Operating Conditions
- 3.3 Environmental Operating Conditions
- 3.4 Power Supply Dimensioning
- 3.5 I/O Characteristics
- 3.6 Auxiliary ADC
- 3.7 Performance
- 3.8 Component Reliability
- 3.9 Package Description
- 3.10 Packing Information
- 3.11 Storage Conditions
- 3.12 Mounting Considerations
- Signal and Pins
- Acronyms
GM01Q DATASHEET PROPRIETARY 4
SEQUANS Communications
2
Regulatory Approval
Note:
This section applies to GM01R63QR5 and GM01R63QR7 part numbers.
Attention
GM01R63QR5 FCC-ID: 2AAGMGM01Q (single modular approval)
GM01R63QR7 FCC-ID: 2AAGMGM01QA (single modular approval)
This
above identified LTE radio module is not intended to be provided to
end-users but is for installation by OEM integrators only.
Installation/Integration
OEM integrators must follow Sequans installation instructions to provide for and benefit from
FCC compliant module integrations and must abide especially by the following:
The only FCC-compliant LTE bands are : band 2, band 4, band 12 and band 13.
The maximum antenna gain values (accounting for cable attenuation) to comply with the FCC
maximum ERP/EIRP limits and with RF Exposure rules:
• LTE band 2 (1800 MHz): 2.1 dBi
• LTE band 4 (1700 MHz): 2 dBi
• LTE band 12 (700 MHz): -2 dBi
• LTE band 13 (780 MHz): -2.4 dBi
The Sequans' module integration guidelines must be closely followed.
Compliance of host integrations of the module is limited to hosts adaptation
designs which are identical to Sequans' reference design.
Host integrations with adaption designs deviating from Sequans' reference
design require either class 2 permissive change to this modular approval or a
separate host approval with different FCC-ID;
Host integrations with co-located (simultaneously operating) radio
transmitters must be evaluated in accordance with FCC multi-transmitter
rules and may require either class 2 permissive change to this modular
approval or a separate host approval with different FCC-ID, dependent on the
result of the evaluation; Inquiry at FCC or a TCB is urgently recommended.
Integrations of the module into host products which are intended for portable
use, i.e. less than 20cm distance between its radiating structures (antenna) and
the body of nearby persons, or which otherwise put additional technical
requirements like Hearing Aid compatibility require either class 2 permissive
change to this modular approval or a separate host approval with different
FCC-ID;