User's Guide
Table Of Contents
- GM01Q-STMOD Test Kit User Guide
- Preface
- About this Manual
- GM01Q-STMOD Test Kit Presentation
- Getting Started
- Setup and Troubleshooting
- Regulatory Statements
- Glossary and Abbreviations
GM01Q-STMOD TEST KIT USER MANUAL PROPRIETARY 5
SEQUANS Communications
2
Getting Started
2.1 Prepare the Test Kit
1. Before plugging the discovery board for the first time to your laptop, install
the en.stsw-link009 driver that can be downloaded on
https://www.st.com/en/development-tools/stsw-link009.html.
2. Connect the antenna or your SMA RF cable to the board LTE RF connector
3. Insert your 3FF SIM card in the SIM slot.
4. Connect the GM01Q-STMOD board to the STM32 discovery board
(GM01Q module on the upper side and SIM slot on the bottom) as shown
on Figure 2-1.
Figure 2-1: GM01Q-STMOD Test Kit Connected to Discovery Board
5. Plug the USB cable from the Discovery Board to your PC.
Rev4 Draft