Data Sheet

REGULATORY APPROVAL
FCC REGULATORY APPROVAL
32 PROPRIETARY GM02S DATASHEET (PRELIMINARY)
SEQUANS Communications
End-product Labelling
•FCC-ID
The module's FCC-ID must either be visible from the exterior of the host
product (e.g. per window) or per electronic display, or shall be displayed
on an additional exterior label per the following or similar string:
contains FCC-ID: 2AAGMGM02S
• Digital Device - Unwanted Emissions Notice
If the end-product falls under part 15 of the FCC rules (it shall display the
following user notice on its exterior acc. to part 15.19 (the notice may be
printed in the manual in case the host is too small):
This device complies with Part 15 of the FCC Rules.Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
• Further Labelling Requirements may apply dependent on the FCC rule
parts relevant to the host product.
• End-product User Instructions / Notices in the Manual
At a minimum, end-product users must be provided with the following
notices at a prominent location of the product literature furnished with the
product:
* Product Modifications
Modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this
equipment.
* RF Exposure Compliance
This equipment complies with FCC radio frequency radiation exposure
rules and limits set forth for an uncontrolled environment, when
installed and operated with minimum distance of 20cm between its
radiating structures (antenna) and the body of nearby persons and
when not operated simultaneously with other nearby
radio-transmitters.
• Maximum Antenna Gain
The user instructions of end-products equipped with standard external
antenna connectors for the modular radio transmitter providing the option
to connect other antennae than those which may or may not be bundled
with the end-product must list the maximum allowed antenna gain values
as derived from those given above, accounting for the cable attenuations of
the actual installation.