User's Manual

SEQUANS Communications Confidential and Proprietary
GM01Q/NB01Q User Manual,
Revision 1 Application Note
8/22
3. Getting Started
3.1. Board Preparation
 Connect the Antenna or your SMA RF Cable to the board LTE RF Connector
 Insert your 3FF SIM Card in the SIM slot.
 Plug the mini-USB cable from your PC to the board USB Port A
3.2. Drivers installation
 When you plug the USB connector for the first time in your PC, you need to wait for
about one minute, the time to allow the drivers to be auto-installed on windows.
 The USB is used to power the board. It also connects the on-board UART-USB bridge
IC to provide ACM interfaces (virtual COM) in order to access the board through UART.
 You should see a window popping up with the following information
 If for some reasons, the driver fails to auto-install on windows, you can always install
them manually from http://www.ftdichip.com/Drivers/VCP.htm FTDI driver labelled
UART/USB
 After driver installation, it is safer to unplug the Test Kit and reboot your PC.