Integration Guide
Table Of Contents
- Module Integration Guide
- Preface
- About this Guide
- Introduction
- Manufacturing Process
- Hardware Integration Recommendations
- PCB Layout Rules
- Bring-Up and Testing
- Hardware Test Preparation
- Abbreviations
HARDWARE INTEGRATION RECOMMENDATIONS
HOST COMMUNICATIONS SIGNALS
14 PROPRIETARY MODULE INTEGRATION GUIDE
SEQUANS Communications
3.3.5.2 Default Configuration
UART2 default software configuration allows firmware upload when the
device is configured in FFH mode, then it switchs in debug mode (enabling
DVTool, DMTool).
The serial link settings are as follows:
• Baud rate: 921600
• Data: 8 bits
•Parity: None
• Stop : 1 bit
• Flow control: Hardware (RTS/CTS)