Integration Guide
Table Of Contents
- Sequans Monarch Go-GPS BLE
- Datasheet and Hardware Integration Guide
- Legal Notices
- Document Revision History
- Table of Contents
- Introduction
- 1. Product Datasheet
- 1.1. General Description
- 1.2. Applications
- 1.3. System Architecture
- 1.4. Mechanical Overview
- 1.5. Product Characteristics
- 1.6. Digital board-to-board connector
- 1.7. Electrical
- 1.8. Environmental
- 1.9. Mechanical drawings
- 1.10. Label
- 1.11. Certifications
- 1.12. Regulatory Approval
- 1.13. Export Control Certification Number (ECCN)
- 2. Integration guideline
- 3. Verizon SIM sign-up procedure to activate ThingSpace IoT SIM
- 4. Troubleshooting
Confidential and Proprietary
Monarch Go-GPS-BLE Datasheet and Hardware Integration Guide, Rev 1
11/28
1.10. Label
The following identities are marked on a 30x12mm heat resistant label on Monarch Go-GPS BLE device:
1.11. Certifications
The certifications apply to Monarch Go-GPS – A3 hardware version.
Verizon
certification
Verizon Open Development Device Certification
LTE cat-M1, band 13 and band 4
Certification ID: 13215
Regulatory
approval
FCC part 15 / ISED
LTE band 13 and band 4
FCC-ID: 2AAGMGMQGOB
IC: 12732A-GMQGOB
1.12. Regulatory Approval
1.12.1. FCC statement
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
RF exposure safety
This device complies with the FCC RF exposure limits and has been evaluated in compliance with mobile
exposure conditions.
The equipment must be installed and operated with minimum distance of 20 cm of the human body.
Class B device notice
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: