Integration Guide
Table Of Contents
- Sequans Monarch Go-GPS BLE
- Datasheet and Hardware Integration Guide
- Legal Notices
- Document Revision History
- Table of Contents
- Introduction
- 1. Product Datasheet
- 1.1. General Description
- 1.2. Applications
- 1.3. System Architecture
- 1.4. Mechanical Overview
- 1.5. Product Characteristics
- 1.6. Digital board-to-board connector
- 1.7. Electrical
- 1.8. Environmental
- 1.9. Mechanical drawings
- 1.10. Label
- 1.11. Certifications
- 1.12. Regulatory Approval
- 1.13. Export Control Certification Number (ECCN)
- 2. Integration guideline
- 3. Verizon SIM sign-up procedure to activate ThingSpace IoT SIM
- 4. Troubleshooting
Confidential and Proprietary
Monarch Go-GPS-BLE Datasheet and Hardware Integration Guide, Rev 1
19/28
UE5.2.0.1
SR1.2.0.0-xxxx
LR5.2.1.0-yyyy
This will verify that the UART1 connection between Host Board MCU and Monarch Go-GPS BLE is
functional and correctly configured (voltage level, baud rate, hardware flow control).
The next step is to verify connectivity to Verizon network, this can be done typing
AT+PING=www.sequans.com command.
2.5. Configuration
The default LTE LED behavior can be changed using AT+SQNLED, this is a persistent setting.
AT+SQNLED=0 : Set LTE blink mode Off. The LTE LED is switched off.
AT+SQNLED=1 : Set blink mode On. The LTE LED will blink according to the system state:
o AT+CFUN=0 or 4. The modem is stopped or in Airplane mode. The LED is permanently
turned off.
o AT+CFUN=1. LTE data transfer. The LTE LED is permanently turned on.
o AT+CFUN=1. The modem is registered to the network, no data transfer (modem is in
RRC Idle). The LTE LED blinks (typically 1280 ms on, 19200 ms off).
o AT+CFUN=1. Limited Network Service (no SIM, network search). The LED blinks
(typically 500 ms on, 500 ms off).
o AT+CFUN=1. The modem is in sleep or deep sleep mode (eDRX or PSM). The LTE LED
is permanently turned off.
AT+SQNLED=2 : Set GPS blink mode Off. The GPS LED is switched off.
AT+SQNLED=3 : Set GPS blink mode On. The GPS LED will blink according to the system state:
the GPS is active (1000ms on, 2000ms off)
AT+SQNLED=4 : Set BLE blink mode Off. The BLE LED is switched off.
AT+SQNLED=5 (default): Set BLE blink mode On. The BLE LED will blink according to the
system state. Note that enabling BLE LED will prevent Monarch Go-GPS BLE to go in deep sleep
mode during advertising mode.