Integration Guide
Table Of Contents
- Sequans Monarch Go-GPS BLE
- Datasheet and Hardware Integration Guide
- Legal Notices
- Document Revision History
- Table of Contents
- Introduction
- 1. Product Datasheet
- 1.1. General Description
- 1.2. Applications
- 1.3. System Architecture
- 1.4. Mechanical Overview
- 1.5. Product Characteristics
- 1.6. Digital board-to-board connector
- 1.7. Electrical
- 1.8. Environmental
- 1.9. Mechanical drawings
- 1.10. Label
- 1.11. Certifications
- 1.12. Regulatory Approval
- 1.13. Export Control Certification Number (ECCN)
- 2. Integration guideline
- 3. Verizon SIM sign-up procedure to activate ThingSpace IoT SIM
- 4. Troubleshooting
Confidential and Proprietary
Monarch Go-GPS-BLE Datasheet and Hardware Integration Guide, Rev 1
28/28
4. Troubleshooting
4.1. Replacing the SIM card
The SIM card can be removed and replaced after opening Monarch Go-GPS enclosure (bottom). When
the SIM connector is visible, follow the below steps:
4.2. Connecting a RF cable to LTE connector
Monarch Go-GPS BLE has an SWG_VE series RF connector for LTE signal. It is located inside the
enclosure. Once you remove the mechanical protection (top), you can connect a RF cable reference
MXHQ87WA3000 orderable from Murata. This connector can be used for debug purpose. It is not
intended to be used in operating mode.
Note: this RF connector cannot be used to connect to the GPS or BLE receiver, it is only for the LTE
signal.