User Manual

audio in each voice is gradually moved away from the center by different
amounts. Every other voice goes in a different direction. This provides a wide
stereo field as you play. Any modulation to Pan will individually move each
voice from its static position as set by the Pan Spread setting.
Note: Use the Audio Out parameter in the Global menu to globally
switch the audio outputs from stereo to mono (and vice versa).
Delay: 0...127 – Sets a delay between the time the amplifier envelope is
triggered and when the Attack portion actually begins.
Attack: 0…127 –
Sets the Attack time of the VCA ADSR envelope generator.
Decay: 0…127 – Sets the Decay time.
Sustain: 0…127 – Sets the Sustain level.
Release: 0…127 – Sets the Release time.
Envelope 3
Destination: see table – Sets the Envelope 3 destination. See Modulation
Destinations on page 35 for a list of possible destinations.
Amount: -127…+127 – Sets the amount of Envelope 3.
Velocity: 0…127 – Sets the amount of key velocity controlling the level of
envelope 3.
Delay: 0…127 – Sets a delay between the time Envelope 3 is triggered and when
the Attack portion actually begins.
Attack: 0…127 – Sets the Attack time of Envelope 3.
Decay: 0…127 – Sets the Decay time.
Sustain: 0…127 – Sets the Sustain level.
Release: 0…127 – Sets the Release time.
LFOs
The Prophet '08 has four Low Frequency Oscillators (LFOs) per voice. To select
a specific LFO for editing, press the appropriate switch, 1–4. Turning a knob
will then adjust the parameters of the selected LFO.
16