User Manual

41
1011 nnnn 64 0vvvvvvv Damper pedal – holds envelopes in Sustain if
0100 0000 or higher
1011 nnnn 123 0vvvvvvv All Notes Off – clear all MIDI notes
1011 nnnn 121 0vvvvvvv Reset All Controllers – clears all MIDI controllers
to 0, MIDI volume to maximum
See sections below for additional Continuous Controller (CC) and Non-
registered Parameter Number (NRPN) messages received.
Transmitted Channel Messages
Status Second Third Description
1000 nnnn 0kkkkkkk 0000000 Note Off.
1001 nnnn 0kkkkkkk 0vvvvvvv Note On.
1011 nnnn 0vvvvvvv 0vvvvvvv Control Change; see “Transmitted Controller
Messages” table following
1100 nnnn 0ppppppp Program change, 0 – 127 for Programs 1 – 128
within current Bank
1101 nnnn 0vvvvvvv Channel Pressure
1110 nnnn 0vvvvvvv 0vvvvvvv Pitch Bend LS Byte then MS Byte
Notes: 0kkkkkkk Note number 0 – 127
nnnn Channel number 0 to 15 (MIDI channel 1-16). Ignored if MIDI
channel set to ALL
0vvvvvvv Value
Transmitted Controller Messages
Status Second Third Description
1011 nnnn 0000 0001 0vvvvvvv Mod Wheel
1011 nnnn 0000 0010 0vvvvvvv Breath Controller – when assigned to Pedal/CV
1011 nnnn 0000 0100 0vvvvvvv Foot Controller – when assigned to Pedal/CV
1011 nnnn 0000 0111 0vvvvvvv Volume – when assigned to Pedal/CV
1011 nnnn 0100 1010 0vvvvvvv Brightness – when assigned to Pedal/CV
1011 nnnn 0000 1101 0vvvvvvv Expression – when assigned to Pedal/CV
1011 nnnn 0010 0000 0vvvvvvv Bank Select – 0 to 2
1011 nnnn 0100 0000 0vvvvvvv Damper pedal – sends 0 if off, 0100 0000 when
on
See sections below for additional Continuous Controller (CC) and Non-
registered Parameter Number (NRPN) messages transmitted.
Additional Continuous Controllers
(CCs) Transmitted/Received
The following table details how CCs are mapped onto the Prophet ’08’s
controls. They are transmitted when MIDI Parameter Send is set to CC in
Global, and recognized when received when MIDI Parameter Receive is set to
either CC or All in Global.