Quick Start Guide

DJ-FX
The DJ-FX in Serato DJ are powered by iZotope™. Click the FX tab
to open the FX panel. Select either 1, 2 or M to assign the selected effect
bank to a deck or Master Output. To activate an effect, click the ON button
on your FX UNIT in the software, or the EFFECT button on your controller.
You can adjust effect parameters by using either software controls, or the
SELECT/CONTROL knobs and the EFFECT button on the controller.
There are two available modes in the DJ-FX. Single FX Mode allows you
to select one effect per FX bank, and has multiple parameters that can
be adjusted. Multi FX Mode allows you to select up to three effects per
FX bank, and adjust only one parameter, the FX Depth. The same effects
available in Single FX mode are available in Multi FX mode, as well some
additional presets.
You can select between the two FX modes by clicking either the Single FX
mode button or Multi FX mode button
Reloop Beatmix 2
Control
Single FX mode Shift
FX 1 Adjust Parameter 1
& Effect On/Off
when knob is turned
Select Effect
FX 2 Adjust Parameter 3 Select Effect
FX 3 Adjust Parameter 5 Select Effect
Reloop
Beatmix 2
Control
Single FX mode Shift
FX 1 Adjust Slot 1 Parameter & Effect
On/Off when knob is turned
Select Effect in Slot 1
FX 2 Adjust Slot 2 Parameter & Effect
On/Off when knob is turned
Select Effect in Slot 2
FX 3 Adjust Slot 3 Parameter & Effect
On/Off when knob is turned
Select Effect in Slot 3
The effect time is set using the tracks BPM value, but by applying the
Beats Multiplier you can increase or decrease the effect timing. Modify this
by using the BEATS knob on the controller. Automatic tempo requires that
the track on the deck assigned to the FX Unit has BPM information. Manual
tempo mode allows you to tap in the tempo yourself.
NOTE: To change to Manual Tempo mode, simply tap the BEATS knob
until a desired rate is established. To return to AUTO mode, click and hold
BEATS for 1 second.