User's Manual

of 255.255.255.0) and it will beep once to indicate the reset has occurred
• If the NAS administrator’s password is lost, press and hold this button for 10
seconds. The password will then be cleared (no password), and the NAS will
beep again.
USB Port
• Connect your USB Hard Disk Drive or USB Flash Drive here. The USB
HDD support FAT and NTFS file format
• Connect USB printer
USB Eject Button
Press and release to prepare the USB device for removal. When the USB LED
starts blinking slowly, it is safe to remove the USB device.
LAN
connector
Use this to connect the NAS to your 10BaseT or 100BaseT hub.
Power Switch
This is a spring-loaded "Soft Switch".
If power is Off, press once to turn On.
If power is On, press once to start the Shutdown sequence. During Shutdown, the
Ready LED will blink. When Shutdown is completed, all LEDs will turn off.
Audible Warnings
Audible warnings are given by the following signals.
1 Beep
Reset button or power switch is pressed or system is ready to use
2 Beeps
Repeated every 5 seconds
for 1 minute.
NAS is a DHCP client, but no DHCP Server responded to the DHCP
client request. This means that the NAS could not obtain a valid IP
address.
Page 9