User's Manual

Default Transmit Key
Select which WEP key (1-4) will be used when the Access Point
sends data. Make sure the receiver is using the same key.
Key 1 ~ Key 4
WEP keys enable you to create an encryption scheme for wire-
less LAN transmissions. Manually enter a set of values. (Do not
leave a key field blank, and do not enter all zeroes. These are
not valid key values.)
If you are using 64-bit WEP encryption, then each key must
consist of exactly 10 hexadecimal characters in length. If you
are using 128-bit WEP encryption, then each key must consist of
exactly 26 hexadecimal characters in length. Valid hexadecimal
characters are "0"-"9" and "A"-"F".
WPA
WPA
WPA is an upgrade to the WEP (Wired Equivalent Privacy)
standard for securing your wireless network.
Pre-Shared Key WPA Pre-Shared Key (PSK) is a field where the password is
entered. All wireless clients must also use this password to gain
access to the network. Note that the Key format must also match
the setting for the wireless clients. Its length rangs from 8bytes
to 63bytes.
Group Rekey Interval
WPA Group Rekey Interval is used to specify the frequency of
encryption key rotations. The lower the number, the faster your
encryption key will rotate, however, setting this number too low
may cause your wireless network to slow down.
Page 45