User's Manual

clicked the "Prepare Disk" button. (See below for details of this
button.)
• Prepared Disk is ready for use
Self-test
(S.M.A.R.T.)
This can have any of the following values:
 N/A No disk is available.
 Not Tested No S.M.A.R.T. check has been performed on this
drive.
 Test OK No errors were found in the last test.
 Errors The S.M.A.R.T. check found errors on the drive. If
this happens a few times, the disk should be replaced.
Scandisk
The status field can have any of the following values:
• N/A No disk is available.
• No Scan performed No Scandisk has been performed recently
on this drive.
• Scandisk in progress Scandisk operation is in progress. The
disk cannot be used while a Scandisk is in progress. If required,
use the "Start/Stop" button to terminate the Scandisk operation
and gain access to data on the disks. (To see the results of the
Scandisk operation, use the "View Disk Log" button.)
• Scandisk completed The last Scandisk operation has been
completed. You can use the "View Disk Log" button to view the
results.
• Scandisk terminated The last Scandisk operation was can-
celled by the Administrator before it was completed.
Page 73