User Manual

Setup

Initial setup should be performed using the supplied Windows-based setup Wizard. This

program can locate the Wireless/Ethernet Network Camera even if its IP address is invalid for

your network. You can then configure the Wireless/Ethernet Network Camera with appropriate

TCP/IP settings for your LAN.

Subsequent administration can be performed with your Web browser, as explained in Chapter

3 - Web-based Administration.

Setup Procedure

1. Insert the supplied CD-ROM into your drive. If the setup program does not start

automatically, run Netcam_Setup.exe in the root folder.

• You will see the Welcome screen shown below.

• Click the Setup button to start the setup Wizard

Figure 4: Welcome Screen

2. The next screen, shown below, will list all the Wireless/Ethernet Network Cameras on

your LAN.