User Manual

Chapter 3

Advanced Viewing Setup

This Chapter provides information about the optional settings and features for

viewing video via the Wireless/Ethernet Network Camera. This Chapter is for

Administrators only.

Introduction

After finishing setup via the Windows-based Wizard, the Wireless/Ethernet Network Camera

can immediately be used by all users on your LAN.

Refer to Chapter 5 - Viewing & Recording for details on viewing and recording live video.

This chapter describes some additional settings and options for viewing live Video:

• Adjusting the video image

• Controlling user access to the live video stream

• Making video available from the Internet

• Using the Motion Detection/E-mail feature

Adjusting the Video Image

If necessary, the Wireless/Ethernet Network Camera Administrator can adjust the Video image.

Settings are provided for:

• Image size - Select the desired size. The larger sizes require greater bandwidth.

• Image quality - This determines the degree of compression applied to the Video stream.

Higher quality requires greater bandwidth.

• Power Line frequency - Select 50Hz or 60Hz power line frequency, as used in your

region. The correct setting will improve the picture quality under florescent lighting.

• Exposure - Adjust the brightness of the image, if the Auto-Exposure does not give

satisfactory results.

• Color Adjustment - Red, Green, Blue intensity can be adjusted.

• Time Stamp - If enabled, the time will be displayed on the Video image.

• Text Overlay - If enabled, up to 20 characters can be superimposed on the Video image.

This is useful for identifying the camera.

• Audio - If desired, audio can be included in the video stream.

To Adjust the Video Image:

1. Connect to the Web-based interface of the Wireless/Ethernet Network Camera. (See

Chapter 4 - Web-based Management for details.)

2. On the Administration menu, select Image. You will see a screen like the example below.