User Manual

Wireless Router User Guide

2. Connect LAN Cables

• Use standard 10/100 CAT5 network cables to connect PCs to the Switching Hub ports on

the Wireless Router.

• Both 10BaseT and 100BaseT connections can be used simultaneously.

The wired LAN connection, rather than the Wireless

interface, is preferred for first-time router setup.

Once the Wireless configuration is correct, the Wireless

interface can be used for any further configuration.

3. Connect WAN Cable

Connect the DSL or Cable modem to the WAN port on the Wireless Router. Use the cable

supplied with your DSL/Cable modem. .

4. Attach Antenna

Attach the supplied wireless antenna to the connector provided on the back of the Wire-

less Router. Secure the antenna by turning the grooved or ridged ring on the antenna until

snug (Do not over tighten).

5. Connect Printer Cable

Use a standard parallel printer cable to connect your printer to the Printer port on the Wire-

less Router.

6. Power Up

• Power on the Cable or DSL modem.

• Power on the Printer.

• Connect the supplied power adapter to the Wireless Router and power up.

Use only the power adapter provided. Using a different one may cause hardware damage

7. Check the LEDs

• The Status LED should flash, then turn On. If it stays On, or flashing, there is a hardware

error.

• For each active LAN (PC) connection, the LAN Link/Act LED should be ON

• The WAN LED should be ON.

• The Wireless LED should be ON.

• The Print Act LED should be ON.

For more information, refer to LEDs in Chapter 1.