User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 LAN Installation
- Chapter 3 Wireless Print Server Configuration
- Chapter 4 Client PC Configuration
- Chapter 5 BiAdmin Management Utility
- Chapter 6 Web-Based Management
- Chapter 7 Special Features
- Chapter 8 Troubleshooting
- Appendix A Specifications
- Appendix B Windows Server Configuration
- Appendix C Unix Systems
- Appendix D NetWare
Page 16
Figure 9: Print Port Setup (Peer-to-peer Printing)
If your 802.11g Wireless Print Server is not listed:
• Click the "Refresh" button.
• Check that both the 802.11g Wireless Print Server and the printer are
properly connected, and powered on.
• Check that the 802.11g Wireless Print Server has been configured. (Use the
Setup Wizard on the CD-ROM.)
• If using TCP/IP, try installing the NetBEUI protocol. (See the earlier section
Checking your Network Protocols for details.). Then try again.
2. Select the desired port on a 802.11g Wireless Print Server, then click Next. A pop-up
message will inform you if the port has been created successfully.
If you see the following error message, either install Internet
Explorer 4 or later, or follow the procedure in the "Trouble
Shooting - Windows" section of Chapter 8.
3. The printer port will be created, then a screen like the following will be displayed.