User's Manual

Page 28
TCP/IP Tab
Selecting this tab will allow configuration for the TCP/IP network protocol. The basic options
are:
Dynamic IP Address (DHCP) - The IP address is obtained automatically, from a DHCP
Server on your network.
Fixed IP Address - You must enter the IP address, Subnet Mask, and Gateway Address.
IP Address - Select an unused IP address from the address range used on your LAN.
Subnet Mask - Use the same values as PCs on your LAN (or on the same LAN
segment, if you have a Router).
Gateway - Use the same values as PCs on your LAN (or on the same LAN segment, if
you have a Router).
The 802.11g Wireless Print Server also supports the Auto-IP function. If the 802.11g Wireless
Print Server is set to Dynamic IP Address, but there's no DHCP server found on the network,
the 802.11g Wireless Print Server will get an IP from the range of 169.254.1.1 ~
169.254.254.254 automatically. In this case, even though the 802.11g Wireless Print Server
was initialized with an Auto-IP, it will change to DHCP whenever a DHCP server is detected.
Figure 20: TCP/IP Screen
The TCP session parameters should only be changed if advised to do so by your Network
Administrator or Print Server Technical Support.