User's Manual

Page 38
Chapter 6
Web-Based Management
This chapter explains how to use your Web Browser to configure the 802.11g Wireless
Print Server.
6
Overview
The 802.11g Wireless Print Server incorporates the HTTP server. This allows you to connect
to the 802.11g Wireless Print Server and configure it using your Web Browser. Most browsers
should work, provided they support tables and forms.
Preparation
Because it supports dynamic IP Address allocation using DHCP, BOOTP, or RARP, the
802.11g Wireless Print Server ships with an IP Address of 0.0.0.0.
This is NOT a valid IP Address.
Therefore, you must do ONE of the following:
• Check your DHCP server (if you have one), and determine the IP Address allocated to the
802.11g Wireless Print Server.
• Use the Diagnostic Button (if fitted) to print a report which includes the current IP
address. (Press the Diagnostic Button, and hold it for 2 seconds.)
• Use the Setup Wizard, BiAdmin or another 802.11g Wireless Print Server utility to
allocate a valid IP Address to the 802.11g Wireless Print Server.
• Add an entry to the arp table to associate the hardware address of the 802.11g Wireless
Print Server with the desired IP address, as follows:
arp -s IP_Address 00:c0:02:xx:xx:xx (Unix)
arp -s IP_Address 00-c0-02-xx-xx-xx (Windows)
Where:
IP_Address is the IP Address you wish to assign to the 802.11g Wireless Print Server.
00:c0:02:xx:xx:xx is the hardware address of the 802.11g Wireless Print Server.
Example (Unix):
arp -s 192.168.0.21 00:c0:02:12:34:56
Example (Windows):
arp -s 192.168.0.21 00−c0−02−12−34−56
Note: The hardware address of the 802.11g Wireless Print Server is shown on a sticker on the
base of the device.