User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 LAN Installation
- Chapter 3 Wireless Print Server Configuration
- Chapter 4 Client PC Configuration
- Chapter 5 BiAdmin Management Utility
- Chapter 6 Web-Based Management
- Chapter 7 Special Features
- Chapter 8 Troubleshooting
- Appendix A Specifications
- Appendix B Windows Server Configuration
- Appendix C Unix Systems
- Appendix D NetWare
Page 39
Connecting to the 802.11g Wireless Print Server
1. Start your Web Browser.
2. In the Address box, enter HTTP:// followed by the IP Address of the 802.11g Wireless
Print Server.
e.g.
http://192.168.0.100
3. You will then be prompted for the password. If no password has been set, just press
E
NTER.
4. Use the menu bar to move from one screen to another. Remember to save each screen
before changing to a different screen.
Configuration Screens
The following configuration screens are available.
AppleTalk
Figure 28: AppleTalk Screen
AppleTalk zone
AppleTalk zone
This determines which Apple systems can gain access to this printer.
Communication
Printer Object
Type
This value is supplied to Macintosh clients. The default value is
LaserWriter, and normally this should not be changed.
Communication
Protocol
Sets whether the USB printer port uses ASCII or Binary. The
default is Binary.