User's Manual

Physical Details - Network Camera
Front - Network Camera
CS Mount Lens
Adjust focus manually by turning the front lens clear. You also
should ensure that the lens cover remain clean. The image quality is
degraded if the lens cover is dirty or smudged.
Microphone
The built-in microphone is mounted on the front. There is also a
connection for an external microphone on the rear. Connecting an
external microphone will disable the built-in microphone.
Power LED
(Amber)
On - Power on.
Off - No power.
Blinking - The Power LED will blink during start up. This will take
15 to 20 seconds.
Network LED
(Green)
On - Wireless or LAN connection is detected.
Off - Wireless or LAN connection is not detected
Blinking - Data is being transmitted or received via the LAN or
Wireless connection.
Rear - Network Camera
Antenna
For Wireless model, attach the supplied antenna here. The antenna is
adjustable; best results are usually obtained with the antenna
positioned vertically.
Reset Button
This button is recessed; you need a pin or paper clip can be used to
depress it. It can be activated at any time the camera is in the
"ready" mode.
x WPS PBC Mode. For the Wireless Model, when pressed and
released (less then 3 seconds), the Network Camera will be in
the WPS PBC mode (Auto link mode).
x WPS Pin Code Mode. For the Wireless Model, when pressed
and held for over 3 seconds, the Network Camera will be in the
WPS Pin Code mode.
x Reset to manufacturer default value and reboot. When
pressed and held over 10 seconds, the settings of Network
Camera will be set to their default values.
Note:
After this procedure is completed, the Power LED will blink three
times to confirm that the reset was completed successfully.
4